top of page
Writer's pictureVictor Russinko

Try These DIY Solutions to Save $$$

While many home plumbing tasks can be DIY-friendly, more complex issues or persistent problems should be handled by a licensed plumber. Frey Services has a Master Plumber on staff to ensure all Plumbing repairs are done "to code" or better. Try these DIY solutions for simple issues you may have if if you want to save some $. If these fail definitely time to call up FREY for some professional help.



How to Unclog a Drain

  1. Boiling Water: Pour boiling water down the drain to dissolve minor clogs.

  2. Use a Plunger: Create a seal around the drain and plunge up and down vigorously.

  3. Baking Soda and Vinegar: Pour baking soda followed by vinegar down the drain and let it sit before rinsing with hot water.

  4. Plumbing Snake: Insert a plumbing snake into the drain to break up and remove the clog.

  5. Clean the P-Trap: Remove and clean the P-trap under the sink if the clog persists.


How to Fix a Running Toilet

  1. Check the Flapper: Inspect the flapper for wear and ensure it is sealing properly.

  2. Adjust the Chain: Ensure the chain attached to the flapper is not too long or tangled.

  3. Inspect the Float: Adjust the float to ensure the water shuts off at the correct level.

  4. Replace Faulty Parts: Replace any worn-out or damaged components such as the fill valve or flapper.

  5. Test the Toilet: Flush to ensure the running has stopped.


How to Increase Water Pressure

  1. Check for Leaks: Inspect your plumbing for leaks and fix them.

  2. Clear Clogs: Clean aerators and showerheads to remove any mineral buildup.

  3. Adjust the Pressure Regulator: If you have a pressure regulator, adjust it to increase the pressure.

  4. Check the Main Valve: Ensure the main water valve is fully open.


How to Relight a Pilot Light

  1. Turn Off Gas: Turn off the gas valve and wait a few minutes for any gas to dissipate.

  2. Locate the Pilot Light: Find the pilot light assembly with the gas valve and a small knob marked "Pilot."

  3. Light the Pilot: Turn the knob to "Pilot," press it down, and use a long lighter to relight the pilot light.

  4. Hold the Knob: Keep the knob pressed for about 30 seconds after lighting.

  5. Turn the Gas Back On: Once the pilot light is burning steadily, turn the gas valve back to the “On” position.


How to Clean a Showerhead

  1. Remove the Showerhead: Unscrew the showerhead from the pipe.

  2. Soak in Vinegar: Submerge the showerhead in a bowl of vinegar for a few hours to dissolve mineral deposits.

  3. Scrub Residue: Use an old toothbrush to scrub away any remaining buildup.

  4. Rinse and Reattach: Rinse the showerhead with water and screw it back onto the pipe.

  5. Test the Flow: Turn on the shower to ensure a clear and consistent water flow.


Frey Services

286 Houses Corner Rd

Sparta, NJ 07871

973-827-1213

2 views0 comments

Comments


bottom of page